After the top was on, the weatherstripping was installed. The SoffSeal kit came complete with the plastic pins preinstalled in the rubber. They all lined up perfectly.After the top was on, the weatherstripping was installed. The SoffSeal kit came complete w The well liner was glued down to the rear-seat backing tray, then the steel trim piece was reattached. We installed our well liner with the vinyl side down. A common mistake is leaving it vinyl side up. While it may look right at first, when you open the trunk you see the canvas and not the vinyl.The well liner was glued down to the rear-seat backing tray, then the steel trim piece was GM A-body convertibles have a really nasty tendency to tear the tops on the sides near the rear hinges. This is because even properly installed pads will shift over, leaving a hinge exposed, which will snag the top every time. To add some extra protection, we used some cheapie carpet and wrapped each side hinge. Attached with a few zip ties, these flexible pads should keep the top safe and still allow the hinge to fully retract.GM A-body convertibles have a really nasty tendency to tear the tops on the sides near the The top needs to sit out in the sun for a day to let it stretch and break in. Redline Auto Sports recommends leaving the top up for about a month so it will maintain the correct shape.The top needs to sit out in the sun for a day to let it stretch and break in. Redline Auto SOURCES Redline Auto Sports Wilson OK Year One PO Box 129 Tucker GA 30085 800-932-7663 770-496-1949 www.nextgenparts.com/mustang SoffSeal Inc. « | 1 | 2 | 3 | View Full Article By Jefferson Bryant Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
