With a 3M coarse surfacing pad, the entire outer surface of the drum was cleaned of any glazing. The drum must be flat and smooth. If the surface is concave, it should be replaced. This drum was in good shape so it did not need replacement.With a 3M coarse surfacing pad, the entire outer surface of the drum was cleaned of any gl The servo pin was checked for clearence and was in spec so the washer was installed A new filter and cork gasket finished off the internals of the build. Straughn says to never use silicone sealant on a tranny pan; there are several small ports on the gasket rail that will get plugged if silicone is used, which will smoke the transmission.A new filter and cork gasket finished off the internals of the build. Straughn says to nev The second gear accumulator body was modified with the springs supplied in the Trans-Go kit. Using two springs gives the trans a very firm shift; using all three is for full-race applications only and will probably be too harsh for the street. We used two for the Impala.The second gear accumulator body was modified with the springs supplied in the Trans-Go ki After the shift kit was installed, the valvebody was bolted down to the case and the electrical plugs were once again connected.After the shift kit was installed, the valvebody was bolted down to the case and the elect The final step was installing the new rear seal. Brass hammers are a must when dealing with a transmission; breaking stuff sucks. endThe final step was installing the new rear seal. Brass hammers are a must when dealing wit SOURCES ATI Performance Products 800-284-3433 www.atiperformanceproducts.com Whatever It Takes Transmission Parts (WIT) Louisville KY Budget Transmission Stillwater OK « | 1 | 2 | 3 | View Full Article By Jefferson Bryant Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
