|
The inner sleeve on the new lower-control-arm bushing was too small to accommodate the metal shim washers. We cut 1/2 inch off each sleeve and centered it in the bushing to make room for the metal end washers. Now you can press the bushing into the A-arm and install the thin polyurethane washer on the protruding end. Position the metal washers on either side of the bushing and lift the entire arm into the frame bracket. Install the eccentric bolt from the front of the frame bracket and slide the keyed eccentric cam over the bolt end. Rotate the cam until your scribed marks line up. View Related Article
|
|